MSY is now offering a new PC Repairs and Upgrades service, designed to boost your computer's performance affordably. As an introductory offer for this service, we're providing free Hardware Diagnosis to all customers who book online. Our service covers a range of common PC issues:
• Booting problems or blue screen errors • Hard drive failures • Power supply issues • Slow computer performance • Unusual or loud noises • Viruses • Visual glitches and errors
For any of these problems, we are ready to repair and upgrade your PC with new components as needed. Our team of technicians is both friendly and patient, ensuring efficient problem resolution.
Please note: We do not offer laptop repairs.
For more details and to book your service at $0 (online) or $60 (walk-in), please visit MSY's website.
Book online to get a FREE 30-minutes Basic Diagnosis!
PoE UL 294 Power-limited Class 2 PSU UL 60950-1/62368-1 LPS/PS2 PSU
Supported voltage range
48V DC
Max. power consumption
5W
ESD/EMP protection
Air: ±15kV, contact: ±8kV
Sensors
Proximity sensor
Speaker
(1) 8 ohm, 0.7W
LEDs
R/G/B/W
Button
(1) Factory-reset
NFC frequency
13.56 MHz
NFC read range
< 30 mm
NFC standards
ISO 14443A, 14443B, 15693
NFC technology
NFC Tag 1,2,3,4,5 MIFARE Classic MIFAREPlus MIFARE Ultralight MIFARE DESFire
Operating environment
Outdoor use
Operating temperature
-30 to 45° C (-22 to 113° F)
Operating humidity
5 to 90% noncondensing
UL 294 level
Destructive attack: Level I Line security: Level I Endurance: Level I Standby power: Level I
UL 294 statement
Compliance with IEEE 802.3 specifications was not verified as part of UL 294. The equipment is intended to comply with the section of the National Electrical Code, ANSI/NFPA 70, Article 725.121, Power Sources for Class 2 and Class 3 Circuits.
PoE cabling requirements
Cable 5e cabling is the minimum performance category recommended. The performance category utilized should match the transmission speed required at the installation site. The minimal conductor gauge permitted to connect between the PSE or power injector and the PD shall be 26 AWG (0.13 mm2) for patch cords; 24 AWG (0.21 mm2) for horizontal or riser cable.
